Initial settings, Switching the dimmer setting, Switching the rear output setting – Pioneer FH-P4000R User Manual

Page 51: Selecting the digital attenuator

Advertising
background image

Initial Settings

En

51

11

Section

English

Español

Deutsch

F

rançais

Italiano

Nederlands

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.

1 Press

FUNCTION

to select

DIMMER

.

Press

FUNCTION

repeatedly until

DIMMER

appears in the display.

2 Select

DIMMER

on or off with

5/.

Pressing

5/∞ will switch

DIMMER

between on

and off and that status will be displayed (e.g.,

DIMMER :ON

).

Switching the rear output setting

This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,

set the output setting to subwoofer.

• Even if you change this setting, there is no

output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 47).

• Both rear speaker leads output and RCA rear

output are switched simultaneously in this
setting.

1 Press

FUNCTION

to select

REAR SP

.

Press

FUNCTION

repeatedly until

REAR SP

appears in the display.

2 Select full-range speaker or subwoofer
with

2/3.

Pressing

2/3 will switch between

REAR SP

:FUL

(full-range speaker) and

REAR SP :S/W

(subwoofer) and that status will be displayed.

Selecting the digital attenuator

When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in distor-
tion. You can switch the digital attenuator to low
to reduce distortion.
• Sound quality is better at the high setting so

this setting is usually used.

1 Press

FUNCTION

to select

DIG.ATT

.

Press

FUNCTION

repeatedly until

DIG.ATT

appears in the display.

2 Select

DIG.ATT

high or low with

2/3.

Pressing

2/3 will switch

DIG.ATT

between

high and low and that status will be displayed
(e.g.,

DIG.ATT :H

).

Advertising