Standard surround setup, Non-skid pads, Making amplifier settings – Pioneer S-ESR2TB User Manual

Page 2: Connecting your system

Advertising
background image

2

En

SURROUND SPEAKERS

For best results the speakers should be positioned at or

above ear level. Depending upon your room layout and

preferences, the left and right rear speakers should be

positioned on the side walls just the rear of the listening

position, or on the walls.

STANDARD SURROUND SETUP

This is a standard multichannel surround sound speaker

setup for optimal 5.1 channel home theater sound.

NON-SKID PADS

If the center and surround speakers are placed on a hard

surface, such as wood or tile place four non-skid pads on

the bottom flat surface of the speakers.

MAKING AMPLIFIER SETTINGS

Before connecting the speakers, please read the

operating instructions supplied with your amplifier to

select the speaker setting of amplifier :

• CENTER / SURROUND SPEAKERS : SMALL

CONNECTING YOUR SYSTEM

Make sure all equipment is turned off before making any

connections.

• Correct wiring of your speakers is essential for

achieving the best sound quality. Be careful to

ensure proper polarity of connection.

Connect to the speaker terminals on the rear of

the amplifier.

Connect the striped speaker cord to the red (+) terminal

and the other cord to the black (–) terminal as shown

below (for more details, refer to your amplifier instruction

manual).

Connect to the speaker terminals on the rear of
the speakers.

To connect, press the lever and insert the striped

speaker cord into the red (+) terminal and the other

cord into the black (–) terminal as shown below.

After connecting the plugs, pull lightly on the cords to

make sure that the ends of the cords are securely

connected to the terminals. Poor connections can create

noise and interruptions in the sound.

Surround left

Surround right

Center

Front

left

Listening position

Front
right

Subwoofer

(not supplied)

Center speaker

Surround speakers

CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.

D3-4-2-2-3_A1_En

Speakers

Amplifier

Striped half of

speaker cord

Other half of

speaker cord

Black

Red

S-ESR2CR_En.fm 2 ページ 2011年2月16日 水曜日 午後2時29分

Advertising