Pioneer PDK-TS36B - Manual (Page 10)

10
En
Fixing the rotation to the front
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
����
Use a screw that has a nominal
diameter of M4 and length
from 20 mm to 30 mm (13/16 to
1-3/16 inch) to fix the rotation
to the front.
��������������
����������������������
�
�
���
���
���
���
�
��
��
���
���
����
��
��
Detaching the Pioneer Television from the Stand
�������
To remove the Pioneer television from the
stand, be sure to always follow the procedure
described below to prevent accidents.
1
First, confirm that the forward/backward
inclination anchor bolt is securely
tightened.
2
First clear a space on a flat floor etc.
where you can lay the Pioneer television
flat, then lay a sheet to protect it from
scratches or other damage.
3
Remove the speakers.
4
Referring to steps 2 and 3 in “Attaching
the Pioneer Television” (Page 5.), remove
the installation screws (4 screws).
����
Do not remove the screws (M8 x 16 mm: silver) by
procedure 2 in Page 5. The support columns might slip out
of place and fall over.
5
Holding the Pioneer television by its
handles and from the bottom, lift the
display vertically.
6
Place the Pioneer television slowly onto
the sheet laid out in step 2 with its screen
facing downwards.
����
When reattaching the Pioneer television to the stand, be
certain that the left/right support columns are set at the
same angle.
Specifications
External dimensions 577 mm (W) x 321 mm (H) x 380 mm (D) (22-23/32 in. (W) x 12-5/8 in.(H) x 14-31/32 in. (D))
[When using the support columns S]
Weight 10.8 kg (23.9 lbs)
• The above specifications and exterior may be modified without prior notice to improve the product.