Pioneer AVH-P5200BT - Manual (Page 61)

4 Touch Clear.
After selecting a desired item, a confirmation
display appears. Touch
OK to delete the mem-
ory.
# If you do not want to clear the selected mem-
ory, touch
Cancel.
Updating Bluetooth connection
software
This function is used to update this unit with
the latest software. For information on the soft-
ware and updating, refer to our website.
Important
Never turn the unit off and never disconnect the
phone while the software is being updated.
1 Display the system menu.
Refer to Introduction of menu operations on
page 40.
2 Touch Bluetooth Software Update.
3 Touch Start to display the data transfer
mode.
# Follow the on-screen instructions to finish up-
dating the software.
Displaying the Bluetooth
system version
If this unit fails to operate properly, you may
need to consult your dealer for repair. In such
cases, you may be asked to specify the system
version. Perform the following procedure to
check the version on this unit.
1 Turn the unit off.
Refer to Basic Operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 40.
3 Touch Bluetooth Version Information to
display to the version of the Bluetooth
module of this unit.
Adjusting the LCD panel slide
position
You can adjust the LCD panel slide position so
that the panel is set back or forward.
1 Display the system menu.
Refer to Introduction of menu operations on
page 40.
2 Touch Flap Set Back.
3 Touching the Flap Set Back keys allows
you to move the LCD panel back and forth.
The LCD panel slides to the back.
The LCD panel slides to the front.
Setting the automatic open
function
To prevent the display from hitting the shift
lever of an automatic vehicle when it is in the
P (park) position, or when you do not wish the
display to open/close automatically, you can
set the automatic open function to manual
mode.
1 Display the system menu.
Refer to Introduction of menu operations on
page 40.
2 Touch AUTO FLAP to select whether to
open/close the display automatically or
manually.
Each time you touch
AUTO FLAP the setting
switches between:
! ON – The LCD panel will open or close auto-
matically when the ignition switch is turned
on or off.
! OFF – You have to press OPEN/CLOSE to
open/close the LCD panel.
En
61
Section
12
Menu
operations
Menu operations