Pioneer AVH-5300DVD - Manual (Page 9)

Notes
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires dril-
ling of holes or other modifications to the vehi-
cle.
! Do not install this unit where:
— it may interfere with operation of the vehi-
cle.
— it may cause injury to a passenger as a re-
sult of a sudden stop.
! Do not install the display where it may (i) ob-
struct the driver
’s vision, (ii) impair the perfor-
mance of any of the vehicle
’s operating
systems or safety features, including air bags,
hazard lamp buttons or (iii) impair the driver
’s
ability to safely operate the vehicle.
! The semiconductor laser will be damaged if it
overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
! To ensure proper heat dispersal when using
this unit, make sure you leave ample space
behind the rear panel and wrap any loose
cables so they are not blocking the vents
when installing the unit.
5cm cm
Leave ample
space
5 cm
5 cm
! The cords must not cover up the area shown
in the figure below. This is necessary to allow
the amplifiers to radiate freely.
1
1 Do not cover this area.
! Make sure you leave enough gap between the
dashboard and the LCD panel of this unit so
the LCD panel can be opened and closed with-
out contacting with the dashboard.
1
2
3
1 Dashboard
2 Leave gap
3 LCD panel
DIN front/rear-mount
This unit can be properly installed using either
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
DIN Front-mount
1 Decide the position of the side brack-
ets.
When installing in a shallow space, change
the position of side brackets (small).
En
9
English
Section
02 Installation