Pioneer VSX-920-K - Manual (Page 9)

9
Applications Operations
This section explains operations that you do in the application, from opening measurement data to
displaying graphs and saving the data.
Opening measurement data
1
Double click the application shortcut icon on the PC desktop.
You can also start the application by selecting “Program”  “Pioneer Corporation”  “Advanced
MCACC” from the “Start” menu.
The application starts.
2
Connect the USB device onto which the measurement data has been transferred
to the computer’s USB port.
3
Select “Open” under “File” on the menu bar.
4
Select the “.mcacc” file you want to display on the USB device, then click “Open”.
The measurement data is displayed.
• The data used to display the reverberation characteristics graph (Reverb), the group delay characteristics
graph (Group Delay) and the MCACC parameters are not deleted even when the receiver’s power is
turned off. However, for the data used to display the reverberation characteristics graph (Reverb) and the
group delay characteristics graph the data stored in the receiver is overwritten when the reverberations
are measured again. If you wish to display graphs of multiple sets of data, transfer the data to the USB
device each time measurements are made on the receiver.
Note
Continue