Pioneer DEH-P80MP - Manual (Page 60)

Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press Multi-Control and hold until the
clock appears in the display.
3 Turn Multi-Control to select one of the
initial settings.
Turn Multi-Control clockwise to switch be-
tween the functions in the following order:
ClockFM Step (FM tuning step)Auto PI
(auto PI seek)Warning (warning tone)
AUX (auxiliary input)Dimmer (dimmer)
Brightness (brightness)REAR SP (rear
output and subwoofer controller)Telephone
(telephone muting/attenuation)Motion
(motion screen)EVER-SCROLL (ever scroll)
Auto Open (flap auto open)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
Setting the clock
Use these instructions to set the clock.
1 Use Multi-Control to select clock.
Clock appears in the display.
2 Push Multi-Control left or right to select
the segment of the clock display you wish
to set.
Pushing Multi-Control left or right will select
one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi-Control up or down to set
the clock.
Pushing Multi-Control up will increase the
selected hour or minute. Pushing
Multi-Control down will decrease the se-
lected hour or minute.
Notes
! You can match the clock to a time signal by
pressing Multi-Control.
 If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes
10:00.)
 If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
! Even when the sources are off, the clock dis-
play appears on the display.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
Initial Settings
En
60
Section
13