Setup introduction of setup adjustments, Setting the av input, Introduction of setup adjustments – Pioneer AVH-P7800DVD User Manual
Page 96: Setup
Introduction of setup
adjustments
1
1
1
1 Setup menu display
Shows the setup function names.
1
Touch AV MENU and then touch SETUP
to display the setup function names.
The setup function names are displayed and
operable ones are highlighted.
2
Touch ESC to return to the display of
each source.
# To return to the previous display, touch
BACK.
Setting the AV input
You can connect up to two AV components to
this unit and display videos either on
AV
source or
S-DVD source.
Switch the AV input setting depending on the
connected AV components.
! Select VIDEO to watch video of a con-
nected component as
AV source.
! Select S-DVD to watch video of a con-
nected DVD player as
S-DVD source.
! Select B.UP CAMERA to watch a rear view
camera video while you are backing your
vehicle.
When AV component is
connected to AV input 1
% Touch AV INPUT 1 on the setup menu to
select the AV input 1 setting.
Touch
AV INPUT 1 until the desired setting is
selected.
! OFF – No video component is connected
! VIDEO – External video component (such
as portable video player)
! S-DVD – DVD player connected with RCA
cable
# When a DVD player is connected with an AV-
BUS cable, do not select
S-DVD otherwise no pic-
ture will be displayed even if you select
S-DVD as
a source.
About AV input 1
Depending on the unit connected to this unit,
video image may be distorted. In this case,
switch the video image selecting switch on
the underneath of the hide-away unit to the ap-
propriate position to eliminate distortion. Use
a thin standard tip screwdriver to switch the
video image selecting switch on the under-
neath of the hide-away unit.
When AV component is
connected to AV input 2
% Touch AV INPUT 2 on the setup menu to
select your desired setting.
Touch
AV INPUT 2 until the desired setting is
selected.
Setup
En
96
Section
18