Pioneer MVH-7300 - Manual (Page 40)

Message Cause Action
Video frame
rate not sup-
ported The external sto-
rage device
’s
frame rate is
more than 30 fps.
Replace the exter-
nal storage device.
Audio Format
not supported This type of file is
not supported on
this unit. Select a file that
can be played.
Not Found No related files Transfer a file that
can be played.
iPod
Message Cause Action
No Device USB storage de-
vice or iPod is
not connected. Connect a compa-
tible iPod.
Incompatible
USB Non-compatible
iPod Disconnect your
device and replace
it with a compati-
ble iPod.
Check USB The iPod oper-
ates correctly but
does not charge. Make sure the con-
nection cable for
the iPod has not
shorted out (e.g.,
not caught in
metal objects).
After checking,
turn the ignition
switch OFF and
back ON, or dis-
connect the iPod
and reconnect.
Format Read/
Ready Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
Error-02-6X/-
9X/-DX Communication
failed. Disconnect the
cable from the
iPod. Once the
iPod
’s main menu
is displayed, recon-
nect the iPod and
reset it.
iPod failure. Disconnect the
cable from the
iPod. Once the
iPod
’s main menu
is displayed, recon-
nect the iPod and
reset it.
Message Cause Action
Error-02-67 The iPod firm-
ware version is
old. Update the iPod
version.
Stop There are no
songs. Transfer songs to
the iPod.
There are no
songs in the cur-
rent list. Select a list that
contains songs.
No xxxx There is no infor-
mation. Record information
on the iPod.
Not Found No related
songs. Transfer songs to
the iPod.
Bluetooth Telephone
Message Cause Action
Error-10 The power failed
for the Bluetooth
module of this
unit. Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Understanding auto EQ
error messages
When correct measurement of the car
’s inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause Action
Error. Please
check MIC. The microphone
is not connected. Plug the optional
microphone se-
curely into the
jack.
En
40
Appendix
Additional information