Pioneer AVH-2300DVD - Manual (Page 38)

2 Display the system menu.
Refer to Introduction of menu operations on
page 30.
3 Touch Rear Speaker on the system
menu.
4 Touch Rear Speaker to switch the sub-
woofer output or full-range speaker.
5 Touch Preout to switch the subwoofer
or rear output.
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 32).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to
100 kHz. It may be preferable to set the tuning
step to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Turn the unit off.
Refer to Basic operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 30.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching
FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
RDS setting
Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations to those broadcasting
regional programs.
The regional function can be turned on or off
independently for each FM band.
1 Turn the unit off.
Refer to Basic operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 30.
3 Touch RDS Setup on the system menu.
4 Touch Regional on the menu to turn
the regional function on.
# To turn the regional function off, touch
Regional again.
Selecting alternative frequencies
When the tuner cannot get a good reception,
the unit automatically searches for a different
station in the same network.
AF can be turned on or off independently for
each FM band.
1 Turn the unit off.
Refer to Basic operations on page 9.
2 Display the system menu.
Refer to Introduction of menu operations on
page 30.
3 Touch RDS Setup on the system menu.
4 Touch Alternative FREQ to turn AF on.
# To turn AF off, touch Alternative FREQ again.
Note
Sound may be temporarily interrupted by another
program during an AF frequency search.
En
38
Section
10 Menu operations