Connecting the power terminal, 03 connecting the units – Pioneer GM-A6604 User Manual

Page 10

Advertising
background image

Black plate (10,1)

1 Car Stereo
2 Speaker output
3 White/black: CH A, Left *
4 White: CH A, Left +
5 Gray/black: CH A, Right *
6 Gray: CH A, Right +
7 Green/black: CH B, Left *
8 Green: CH B, Left +
9 Violet/black: CH B, Right *
a Violet: CH B, Right +
b Speaker input connector

To speaker input terminal of this unit.

Note

If speaker input wires from a headunit are con-
nected to this amplifier, the amplifier will automa-
tically turn on when the headunit is turned on.
When the headunit is turned off, the amplifier
turns off automatically. This function may not
work with some headunits. In such cases, please
use a system remote control wire (sold sepa-
rately). If multiple amplifiers are to be connected
together synchronously, connect the head unit
and all amplifiers via the system remote control
wire.

Connecting the power
terminal

The use of a special red battery and ground
wire RD-223 (sold separately) is recom-
mended. Connect the battery wire directly to
the car battery positive terminal

+ and the

ground wire to the car body.

WARNING

If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.

1

Route battery wire from engine com-

partment to the vehicle interior.

! When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.

After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive

+ battery term-

inal.

1 Positive + terminal
2 Engine compartment
3 Vehicle interior
4 Fuse (30 A) × 2
5 Insert the O-ring rubber grommet into the

vehicle body.

6 Drill a 14 mm hole into the vehicle body.

2

Twist the battery wire, ground wire

and system remote control wire.

Twist

3

Attach lugs to wire ends.

Use pliers, etc., to crimp lugs to wires.

<5707000008290>10

En

10

Section

03

Connecting the units

Advertising
This manual is related to the following products: