Pioneer CNDV-800HD - Manual (Page 7)

STEP 2; Upgrade procedures
This section describes the upgrade procedures
for your navigation system.
1
Park your vehicle in a safe place.
Leave the ignition in the “ACC” position and
make sure that the handbrake is applied.
2
Press the MAP button to display the cur-
rent location.
Be sure to display the map of current position.
The updating cannot start at the other
screens, such as the scroll mode, the naviga-
tion menu and AV screen.
3
Press OPEN CLOSE button and insert the
upgrade disc into the disc loading slot.
The message confirming whether or not to
start the update will appear.
❒ If the message doesn’t appear, eject the
disc and display the map of current posi-
tion and then reinsert the disc.
4
Touch [Yes].
❒ To cancel the update, touch [No].
Important notice:
The update has two phases.
Phase 1; Update the database
In this phase, take notice of the followings:
— All the functions other than AM and FM
are disabled during update. You can per-
form simplified operations by using the
TRK (/) button and VOL (/) but-
ton. (We recommend changing the AV
source to AM or FM before you start the
update.)
— The update takes approximately 3 hours in
total.
— If you turn the ignition switch off (the navi-
gation system turns off) or eject the
upgrade disc, the update resumes when
the navigation system turns on or the disc
is reinserted.
Phase 2; Update the system pro-
gramme
In this phase, take notice of the followings:
— No functions are available.
— The update takes approximately 10 min-
utes.
— NEVER stop the engine of your vehicle nor
turn off the power supply to the navigation
system until the installation is completed.
Turning the power off in this phase causes
a malfunction or failure of the navigation
system.