Pioneer SC-LX76-K - Manual (Page 35)

35
03
Connecting your equipment
Connecting the multichannel analog inputs
SC-LX86 only
For your Blu-ray Disc player and DVD player may have 5.1, 6.1 or 7.1 channel analog outputs (depending on
whether your player supports surround back channels). Make sure that the player is set to output multichannel
analog audio.
DVD IN
SUBWOOFER MULTI CH IN
SURR BACK SURROUND CENTER FRONT
L
R
SUBWOOFER MULTI CH IN
SURR BACK SURROUND CENTER FRONT L
R
BD IN
DVD
IN
IN 1
(DVD)
IN 2
(SAT/CBL)
IN 3
(DVR/BDR)
IN 4
(VIDEO)
BD IN
DVD IN
IN 1 (DVD) IN 2 (SAT/CBL) IN 3 (DVR/BDR) IN 4 (VIDEO)
R L
SURROUND
OUTPUT
R L
FRONT
OUTPUT
CENTER
OUTPUT
SUBWOOFER
OUTPUT
R L
SURROUND BACK
OUTPUT VIDEO
VIDEO OUT
DVD player, etc.
HDMI OUT
Select one
! For instructions on playing the multichannel analog inputs, see Selecting the multichannel analog inputs on
page 49 .
! If there is a single surround back output, connect it to the SURR BACK L jack on this receiver.
! To use a 5.1-channel speaker set, use the surround speakers for the surround channel, not the surround back
channel.
! The sound from the surround back terminals will depend on how you have configured the Speaker system set-
ting on page 97 .
! The audio signal input to MULTI CH IN cannot be downmixed.
! To input video signals using an HDMI cable, MULTI CH IN must be selected at Input under Input Setup and
the connected HDMI terminal must be assigned to HDMI Input. For details, see The Input Setup menu on
page 46 .
! To input video signals using a composite video cable, Multi Ch In Setup must be selected at Other Setup
and the connected video input terminal must be assigned to Video Input. For details, see Multi Channel Input
Setup on page 103 .
Connecting AM/FM antennas
Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality,
connect external antennas (see
Connecting external antennas on page 36 ).
ANTENNA
AM LOOP FM UNBAL 75
ANTENNA AM LOOP FM UNBAL 75
1
4
5
2
3
a b c
1 Pull off the protective shields of both AM antenna wires.
2 Push open the tabs, then insert one wire fully into each terminal, then release the tabs to
secure the AM antenna wires.
3 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
! If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. c) before
clipping the loop to the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface and in a direction giving the best reception.
5 Connect the FM wire antenna into the FM antenna socket.
For best results, extend the FM antenna fully and fix to a wall or door frame. Don’t drape loosely or leave coiled up.