Pioneer AVG-VDP1 - Manual (Page 12)

11
Installation
Installing this unit
1. Attach the side brackets to this unit.
When this unit is installed on the floor or
the installation board under the passenger
seat, etc., the side brackets should be
attached to the unit.
Use the following holes in the side
brackets.
If the positions of the side plates
are shifted in parallel you can also
use other holes that match up with
the holes in this unit.
When this unit is installed under the pas-
senger seat, etc., use the installation board.
2. Decide on the installation position,
and drill the holes.
3. Secure it firmly using the self-tap-
ping screws.
Drill holes of between
4 and 4.5 mm in
diameter.
Installation board Mark up the positions for
drilling the holes.
Self-tapping screw
(6
× 16 mm)
This unit
Washer faced
screw (4
× 8 mm)
Side bracket