Pioneer SPH-DA100 - Manual (Page 39)

08 Customising preferences
Chapter
39
Engb
Customising preferences
2 Tap [Rear Speaker].
Tapping [ Rear Speaker ] changes the settings
as follows:
Full (default)
When no subwoofer is connected to the
rear output, select “ Full ”.
Subwoofer
When a subwoofer is connected to the
rear output, select “ Subwoofer ”.
❐ Even if you change this setting, there will be
no output unless you turn the subwoofer
output on.
➲ For details, refer to Using the subwoofer
output on page 37.
❐ If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
Setting the RCA output
This product’s preout (RCA rear output or sub-
woofer output) can be used for a full-range
speaker (
Full ) or subwoofer ( Subwoofer ) con-
nection.
Initially, the product is set for a rear full-range
speaker connection (
Full ).
❐ “ Preout ” can be set only when the source is
set to “ OFF ”.
1 Display the “System” screen.
➲ For details, refer to Customising the system
settings on the previous page.
2 Tap [Preout].
Tapping [ Preout ] changes the settings as fol-
lows:
Subwoofer (default)
When a subwoofer is connected to the
RCA rear output, select “ Subwoofer ”.
Full
When no subwoofer is connected to the
RCA rear output, select “ Full ”.
❐ Even if you change this setting, there will be
no output unless you turn the subwoofer
output on.
➲ For details, refer to Using the subwoofer
output on page 37.
•
•
•
•
❐ If you change this setting, subwoofer out-
put in the audio menu will return to the fac-
tory settings.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When “
AF ” (Alternative
Frequencies) or “ TA ” (Traffic Announcements)
is on, the tuning step automatically changes to
100 kHz. But you can set the tuning step to
50 kHz when “
AF ” or “ TA ” is on.
Initially, this function is set to “ 100 kHz ”.
❐ “ FM Setup ” can be set only when the
source is set to “ OFF ”.
1 Display the “System” screen.
➲ For details, refer to Customising the system
settings on the previous page.
2 Tap [FM Setup].
Each time you tap [ FM Setup ] will switch the
FM tuning step between “ 50 kHz ” and
“ 100 kHz ” while “ AF ” or “ TA ” is on.
❐ The tuning step remains at “ 50 kHz ” during
manual tuning.
RDS setting
Limiting stations to regional programming
When “ Alternative FREQ ” is used, the re-
gional function limits the selection of stations
to those broadcasting regional programmes.
❐ This function is effective only when the
radio source is set to FM tuner.
1 Display the “System” screen.
➲ For details, refer to Customising the system
settings on the previous page.