Other information and, Troubleshooting, 20 troubleshooting 20 – Pioneer SBX-300 User Manual
Page 20: Sound, Others, Other information and troubleshooting, Chapter 5
Other Information and Troubleshooting
20
En
Chapter 5
Other Information and Troubleshooting
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something
wrong with this component, check the points below. Sometimes the trouble may lie in another
component. Inspect the other components and electrical appliances being used. If the trouble
cannot be rectified even after checking the points below, ask your nearest Pioneer authorized
service center or your dealer to carry out repair work.
Sound
Problem
Check
Remedy
y
No sound is output.
y
Sound is not output
properly.
Are the cables properly
connected?
y
Connect the cable properly according to the connected devices
(page 11).
y
Insert the cable firmly and all the way in.
y
If there is any dirt on the connection plug and terminal, wipe it off.
Is the audio cable damaged?
If the cable is damaged, replace it with a new one.
Are the connected components
properly set?
Refer to the operating instructions of the connected components and
then check, for example, the volume, input, and speaker settings.
Others
Problem
Check
Remedy
Power does not turned
on.
Is the power cord properly
connected?
y
Plug the power cord securely into the power outlet.
y
Unplug the power cord, wait several seconds, then plug the power
cord back in.
The unit’s power turns off
automatically.
If Auto Power Off is set, the unit’s power automatically turns off. Check
the Auto Power Off setting (page 13).
The unit cannot be
operated.
Unplug the power cord, wait several seconds, then plug the power cord
back in.
Cannot be operated with
the remote control.
Are you operating the remote
control from a point too far
away from the unit?
Operate from within 7 m of the remote control sensor.
Is the battery dead?
Replace the battery (page 5).
Settings I have made have
been cleared.
y
Have you disconnected the
power cord while the unit’s
power was on?
y
Has there been a power
failure?
Wait for at least 10 seconds after the unit display disappears and then
make sure you press the uSTANDBY/ON on the unit or the power
button on the remote control before disconnecting the power cord. Be
particularly careful when the power cord is connected to the AC outlet
on another device because the unit turns off in conjunction with the
device.
I want to adjust the
brightness of the
indicators.
Press the DIMMER on the remote and select the desired display
brightness.
The input selection
indicators are flashing
red.
Before use, unplug the power cord, wait several seconds, then plug the
power cord back in.
If the problem is not resolved, contact the Pioneer Customer Support
Center.
The unit becomes hot
during use.
The temperature of the unit cabinet may increase slightly during use
depending on the operating environment. This is not an indication of a
malfunction so you can continue using the unit without worrying.