Pioneer BDP-LX53 - Manual (Page 46)

For setting the IP address, press  to select
“Yes” or “No”, then press ENTER.
Do you obtain the IP address
automatically?
IP Address
Netmask
Gateway
Next
Yes No
If selecting “Yes”: The IP address is automatically
obtained.
If selecting “No”: The IP address, netmask, gateway
and primary and secondary DNS IP addresses are
manually entered using the screen for inputting
characters. (See page 47.)
Press  to select “Next”, then press
ENTER.
For setting the proxy server, press
 to
select “Yes” or “No”, then press ENTER.
Do you use the proxy server?
Address
Port
Next
Yes No
If selecting “Yes”: The IP address or proxy server
name and port number for the proxy server specified
from your internet service provider are entered using
the screen for inputting characters. (See page 47.)
If selecting “No”: Go to the next step.
Press  to select “Next”, then press ENTER.
If “Ethernet Setup(Wireless)” was selected at step 4,
proceed to step 17.
For setting the Ethernet connections speeds,
press
 to select “Yes” or “No”, then press
ENTER.
Normally select “No”, then press ENTER. Proceed to
step 17.
When the Ethernet connection speeds can be set,
select “Yes” then press ENTER.
10
•
•
11
12
•
•
13
•
14
•
•
Settings
Press  to select the Ethernet connection
speeds, then press ENTER.
As automatic detection is made (factory preset
mode), this setting is not normally necessary. If a
situation occurs in which the Ethernet connection fails,
etc., change the setting and confirm if the Ethernet
connection successfully works. When the connection
speed is set, select “Next”, then press ENTER.
Option
Ethernet Connection Speeds
Next
Auto-Detection
10M Half Duplex
100M Half Duplex
10M Full Duplex
100M Full Duplex
Press  to select “Next”, then press ENTER.
For testing the connection to the internet, after
confirming the settings, press
 to select
“Test”, then press ENTER.
“Test” is available only when setting to obtain the IP
address automatically. “Test” cannot be selected if the
IP address has not been obtained automatically.
Confirm the current setting.
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xx:xx:xx:xx:xx:xx IP Address
Netmask
Gateway
DNS Address
MAC Address
Test Complete
As a result of the test, if the internet connection fails,
enter the setup values manually.
Press  to select “Complete”, then press
ENTER.
15
•
16
17
•
•
18
46