Pioneer DVH-P5000MP - Manual (Page 14)

Installation
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame.
2. Fastening the unit to the factory radio mounting bracket.
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
truss screws (5
× 8 mm) or flush surface screws
(5
× 9 mm), depending on the shape of the
screw holes in the bracket.
En 14
Frame
Insert the release pin into the hole in the
bottom of the frame and pull out to remove
the frame. (When reattaching the frame,
point the side with a groove downwards and
attach it.)
Screw
Factory radio
mounting bracket
Dashboard or Console