Pioneer PDP-S40B - Manual (Page 5)

5
English
English
5. Connect the other end of the speaker
cables to the speaker.
• Connect the cables correctly with respect to the polarity
of the speaker terminals, that is,
cable (Gray) to
terminals (Red) and cable (Black) to terminals (Black).
4. Connect the supplied speaker cables
to the rear of plasma television.
• Connect the cables correctly with respect to the polarity
of the plasma television speaker terminals, that is,
cable
(Gray) to terminals (Red) and cable (Black) to
terminals (Black).
NOTE:
• Press the lever and insert the end
of the cable.
• When you release the lever, it
clamps onto the speaker cable.
Caution
• Be sure to turn the connected devices off and remove
the power cord from the wall outlet beforehand when
changing the connection or installation method.
• If you insert the speaker cable too far so
that the insulation is touching the speaker
terminal, you may not get any sound. Please
insert it with showing the copper wire.
• Check if the end of the speaker cables are
securely connected to the terminals by
slightly tugging on the cable after making
connections. Loose connections may result
in sound dropouts or noise.
• If there is a short in the and cables caused by an
exposed lead wire, excessive load may be applied to the
plasma television, resulting in interrupted operation or
malfunction.
• Incorrect connections of the speaker cable to the right
or left of the plasma television terminals with respect to
the polarity may result in insufficient stereo sound effects,
delivering poor bass sounds or unstable sound image.
• Bundle the cable without pulling.
6. Bundling the cables.
• Bead bands are included with the plasma television.
• Use the bead bands as necessary.
• When tidying up your speaker cables, make sure to
bundle them so that they are not subjected to any
pressure.
Black
Gray Gray Black
Speaker terminal
Speaker terminal Speaker cable Speaker terminal
Red
Red
Black Red Black
Gray
Speaker cable
Bead Band
Rear of Display