Pioneer MEP-7000 - Manual (Page 4)

4
En
<For Windows 2000>
• If the [ Digital Signature Not Found] message appears
during installation, click on the [ Yes] button to continue the
installation process.
5 When installation is completed, the [Installation is now
complete.] message will appear. Click on the [Finish] button
to complete the process.
[3] Connecting the MEP-7000 to a computer
First, use the special remote control cable to connect the
remote control sockets on the rear sides of the MEP-7000 drive
unit and control unit.
Next, use a USB cable to connect the PC connector (USB port)
on the rear of the MEP-7000 drive unit to one of the computer’s
USB ports, then turn on the power switch located on the rear
of the MEP-7000’s drive unit.
When the MEP-7000 is first connected to a computer or when
the computer’s USB port is reconnected, the message
[
Installing device driver software] may appear on the
computer monitor. In this case, simply wait until the message
[
Your devices are ready for use] is displayed.
<For Windows XP>
• During the installation process, if the computer displays the
message [ Can Windows connect to Windows Update to
search for software?] select [No, not this time], then click
on the [
Next] button to continue the installation process.
• During installation, if the computer displays the message [ What
do you want the wizard to do?] select [Install the software
automatically (Recommended)], then click the [Next] button
to continue installation.
• If the [ Hardware Installation] message appears during
installation, click on [ Continue Anyway] to continue the
installation process.
<For Windows 2000>
• If the [
Digital Signature Not Found] message appears during
installation, click on the [ Yes] button to continue the installation
process.