Pioneer PRS-D200 - Manual (Page 7)

7
EN
G
L
IS
H
Connecting the Unit
Using the Speaker Input
Connect the car stereo speaker output wires to the amplifier using the supplied
speaker input wire with RCA pin cord.
• Slide the input switch to the right.
( Connections when using the speaker input
• As a result of connecting the car stereo speaker output wire to the amplifier, the
power of the amplifier is turned on automatically when the car stereo is turned on. It
is not necessary to connect the system remote control wire in this case.
Note:
• Connect the system remote control wire when the power of the amplifier is not to be turned
on when the car stereo is turned on.
Car Stereo
Speaker output
White: Black: Black: Red:
Left + Left - Right - Right +
Speaker input wire
with RCA pin cord
To RCA input
jack of this unit.
Connecting the Speaker Wires
The speaker output mode can be two-channel (stereo) or one-channel (mono).
Connect the speaker leads to suit the mode according to the figures shown below.
• Do not connect both the RCA input and the speaker input at the same time.
Two-channel (stereo)
One-channel (mono)
(Left)
Speaker
(Right)
Speaker
(Mono)
MAN-PRS-D200-GB.fm Page 7 Monday, February 20, 2006 4:17 PM