Pioneer GM-D8604 - Manual (Page 13)

Specifications
Power source ............................. 14.4 V DC (10.8 V to 15.1 V
allowable)
Grounding system ................... Negative type
Current consumption ............ 33.5 A (at continuous power,
4
W)
Average current drawn ......... 3.1 A (4
W for four channels)
4.4 A (4 W for two channels,
BRIDGE)
4.4 A (2
W for four channels)
Fuse ................................................ 30 A × 2
Dimensions (W × H × D) ... 265 mm × 60 mm ×
200 mm
Weight .......................................... 2.6 kg (Leads for wiring not
included)
Maximum power output ....... 200 W × 4 (4 W) / 600 W × 2
(4
W) BRIDGE / TOTAL
1 200 W (300 W × 4)
Continuous power output ... 100 W × 4 (at 14.4 V, 4 W,
20 Hz to 20 kHz,
≦ 1 % THD)
150 W × 4 (at 14.4 V, 2
W,
1 kHz, ≦ 1 % THD)
125 W × 4 (at 14.4 V, 1
W,
1 kHz,
≦ 1 % THD)
300 W × 2 (at 14.4 V, 4 W
BRIDGE, 1 kHz,
≦ 1 % THD)
250 W × 2 (at 14.4 V, 2
W
BRIDGE, 1 kHz, ≦ 1 % THD)
Load impedance ...................... 4
W (1 W to 8 W allowable)
Frequency response ............... 10 Hz to 50 kHz (+0 dB,
–3 dB)
Signal-to-noise ratio ............... 95 dB (IEC-A network)
Distortion ..................................... 0.05 % (10 W, 1 kHz)
Low pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope .....................
–12 dB/oct
High pass filter:
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope .....................
–12 dB/oct
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 16 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 25 k
W
Speaker .............................. 16 V / 12 k W
Notes
! Specifications and the design are subject to
modifications without notice.
! The average current drawn is nearly the maxi-
mum current drawn by this unit when an
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.
En
13
English
Appendix
Additional information