Pioneer CT-F10 - Manual (Page 5)

5
PULL
PUSH
En
Specifications
Stereo Cassette Deck: CT-F10
System ........................... 4-track, 2-channel stereo
Heads ......................... Recording/playback head x 1
Erase head x 1
Motor ...................................... DC Servo motor x 1
Frequency Response (–20dB recording)
Type I (Normal) tape ................. 20 Hz–16,000 Hz
±
6 dB
Type II (High/CrO2) tape .......... 20 Hz–16,000 Hz
±
6 dB
Signal-to-Noise Ratio ................................... 56 dB
(EIAJ, peak recording level, audio compensation)
Noise Reduction Effect
Dolby B-type NR ON .... More than 10 dB (at 5 kHz)
Wow and Flutter.... 0.07% (WRMS),
± 0.14% (DIN)
Dimensions (with out Stands)
............................. 170 (W) x 268 (H) x 66 (D) mm
Weight ......................................................... 1.5 kg
Accessories
Stand A ................................................................ 1
Stand B ................................................................ 1
Operating instructions ......................................... 1
Warranty card ....................................................... 1
Note: Specifications and design subject to possible
modification without notice, due to improvements.
• To remove Stand B, push the center tab, as
indicated, and slide off.
• To remove Stand A, pull the tab, as indicated,
and slide off.
3 If you plan to use the cassette
deck on a table-top or shelf,
attach Stand B.
Line up the tab on Stand B with the center
hole on Stand A and slot it into place. Stand B
will slide under the two tabs on the back of
Stand A.
If you are going to wall-mount the unit, see
Wall-mounting your system of the main
Operating Instructions.
To insert, hold the
connector and push firmly
into the socket until you
hear it click home.
To remove, hold the
connector securely on
either side with thumb and
forefinger and pull out
from the socket.
Ribbon cables
IMPORTANT: Never connect or disconnect the
system ribbon cables while the power plug is
connected to the wall outlet. Doing so may
damage the unit.
Published by Pioneer Corporation.
Copyright © 2000 Pioneer Corporation.
All rights reserved.
Important
Pioneer bears no responsibility for accidents
resulting from faulty assembly or installa-
tion, insufficient mounting strength of walls
or other building fixtures, misuse or natural
disasters.
Stand B
Stand A