Pioneer AVIC-F220 - Manual (Page 11)

On first-time startup
When you use the navigation system for the
first time, select the language that you want to
use.
1 Start the engine to boot up the system.
2 Press the MODE button of the AV recei-
ver.
After a short pause, the navigation screen ap-
pears.
p The display will turn off if you press the
MODE button of the AV receiver immedi-
ately after the navigation system restarts, so
wait (approximately 10 seconds) after re-
start before pressing the
MODE button.
= For details of the operations, refer to Screen
switching overview on the next page.
3 Touch the language that you want to
use on the screen.
4 Touch the language that you want to
use for the voice guidance.
The navigation system will now restart.
When the navigation system restarts, the AV
receiver screen is displayed.
5 Read the disclaimer carefully, checking
its details, and then touch [OK] if you
agree to the conditions.
The map screen appears.
Regular startup
1 Start the engine to boot up the system.
2 Press the MODE button of the AV recei-
ver.
After a short pause, the navigation screen ap-
pears.
p The display will turn off if you press the
MODE button of the AV receiver immedi-
ately after the navigation system restarts, so
wait (approximately 10 seconds) after re-
start before pressing the
MODE button.
p The screen shown will differ depending on
the previous conditions.
p When there is no route, the disclaimer ap-
pears after the navigation system reboots.
Read the disclaimer carefully, checking its
details, and then touch [
OK] if you agree to
the conditions.
= For details of the operations, refer to Screen
switching overview on the next page.
Engb
11
Chapter
02
Before
you
start
Before you start