Pioneer AVIC F500BT - Manual (Page 99)

The map colour does not switch
automatically between daytime
and nighttime.
[ Night mode] is set to [Day]. Check [ Night mode] setting and make sure
[ Automatic] is selected. (Page 78)
The screen is too bright. An improper value has been set on
“Brightness”. Check the settings.
The display is very dim. [ Night] is selected in “Night
mode ”.
Check the setting of [ Night mode] and select
[ Automatic] or [Day]. (Page 78)
An improper value has been set on
“Brightness”. Check the settings.
No sounds of AV source are pro-
duced.
The volume level will not rise. The volume level is low. Adjust the volume level.
A speaker lead is disconnected. Check the connection.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible. You cannot adjust these with
MULTI-CONTROL. Turn the volume up or down according to
[
Sound settings] on the “Navi Settings”
menu. (Page 83)
The person on the other end of
the phone call cannot hear the
conversation due to an echo. The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo. Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
There
’s no picture while this pro-
duct is attached on the cradle.
The handbrake cord is not con-
nected. Connect the handbrake cord, and apply the
handbrake.
The handbrake is not applied. Connect the handbrake cord, and apply the
handbrake.
The backlight of the LCD panel is
turned off. Turn on the backlight. (Page 92)
Nothing is displayed and the
touch panel keys cannot be
used. The setting for the rear view camera
is incorrect. Select the appropriate setting for the rear
view camera.
The gearstick was placed in [R]
when the rear view camera was not
connected. Press MAP button, and then press MENU
button to return to the “Top Menu” and then
select the correct polarity setting for [ Back
Camera]. (Page 90)
There is no response when the
touch panel key are touched or
a different key responds. The touch panel keys deviate from
the actual positions that respond to
your touch for some reason. Perform the touch panel calibration. (Page
90)
Problems in the AV screen
Symptom Cause Action (See)
The screen is covered with the
caution message and the video
cannot be shown. The handbrake lead is not con-
nected or applied. Connect the handbrake lead correctly, and
apply the handbrake.
The handbrake interlock is acti-
vated. Park your vehicle in a safe place and apply
the handbrake.
No video output from connected
equipments.
No video output from connected
iPod. [ AV Input] setting is incorrect. Establish the setting correctly. (Page 75)
The connection of the USB interface
cable for iPod is incorrect. Connect both USB plug and mini-jack cable
side. (If only one connection has made, an
iPod will not work properly.) (Page 13)
Appendix
Engb
99
Appendix
Appendix