Pioneer AVIC-F3210BT - Manual (Page 18)

After installing this
navigation system
1 Reconnect the negative (
–) terminal of
the vehicle
’s battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (
–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Press the RESET button while the de-
tachable device is attached.
Press the
RESET button on the navigation unit
with a pointed object such as the tip of a pen.
4 Make the following settings.
= For details concerning operations, refer to
Operation Manual.
1 Set the language.
2 Drive an unobstructed road until the GPS
starts receiving the signal normally.
3 Make some necessary adjustments.
! Setting the time
! Change other settings as you prefer
Note
After installing this navigation system, be sure to
check at a safe place that the vehicle is perform-
ing normally.
Engb
18
Section
05 After installation