Pioneer SC-LX57-S - Manual (Page 37)

37
03
Connecting your equipment
MULTI-ZONE setup using speaker terminals (ZONE 2)
Either the surround back or the front wide speaker terminals can be used as the speaker terminals for ZONE 2.
For details, see
Determining the speakers’ application on page 18 .
1 Connect a pair of speakers to the surround back or front wide speaker terminals.
2 Connect a TV monitor to the VIDEO ZONE 2 OUT jack on this receiver.
! COMPONENT VIDEO ZONE 2 OUT can be used to output clear images.
! The GUI screen is not displayed if only the COMPONENT VIDEO ZONE 2 OUT jack is connected.
To use the front wide speaker terminals for ZONE 2:
R
Sub zone (ZONE 2) Main zone
VIDEO IN
ZONE 2
OUT L
B FRONT WIDE / R L
ZONE 2 OUT
B FRONT WIDE /
R L
2
1
To use the surround back speaker terminals for ZONE 2:
ZONE 2
OUT
B FRONT WIDE / R L
ZONE 2 OUT
R
Sub zone (ZONE 2) Main zone
VIDEO IN
L (Single)
A SURROUND BACK
R L
2
1
Secondary MULTI-ZONE setup (ZONE 3)
% Connect a separate amplifier to the AUDIO ZONE 3 OUT jacks on this receiver.
You should have a pair of speakers attached to the sub zone amplifier as shown in the following illustration.
ZONE 3 OUT
ZONE 3
OUT
R L
AUDIO IN
Sub zone (ZONE 3) Main zone
Secondary MULTI-ZONE setup using speaker terminals (ZONE 3)
You must select 5.1ch + ZONE 2+3 in Speaker system setting on page 97 to use this setup.
% Connect a pair of speakers to the front wide speaker terminals.
You should have a pair of speakers attached to the sub zone amplifier as shown in the following illustration.
R
Sub zone (ZONE 3) Main zone
L
B FRONT WIDE / R L
B FRONT WIDE /
R L
1