Pioneer SEP-C1 - Manual (Page 7)

DJS Ver. 1.601 7
1
1-5
Operating the DJS Effecter
You can use the SEP-C1 to operate the Effecter on the [DJ Play] screen in DJS.
1
Press the EFFECT button.
2
Set the effect parameters.
• Use the function buttons, LOAD A button, LOAD B button, select UP and select
DOWN buttons to make the settings.
Functions that are Linked with the [DJ Play] Screen (Effect Functions)
3
Operating with the Rotary Selector
• If you rotate the rotary selector, you can adjust the level and depth of effects
(balance between the original music on the selected channel and the sound effect of
the selected effect).
• If you press the rotary dial, the effect comes ON and the sound effect is output on
the selected channel. Pressing it again makes the effect go OFF.
EFFECT Button
If you press the EFFECT button, the EFFECT
sscreen is displayed in the center display.
Function Buttons
In the EFFECT screen, the eight effect selections,
channel switching and BPM display switching
are assigned.
When using an external mixer
The EFFECT screen cannot be used when the DJS
mixer is set to an external mixer.
Note
1 EFFECT Button
2 Function Buttons (6) :
-［INPUT SELECT］
-［DELAY/ECHO］
-［PAN/TRANS］
-［FILTER/FRANGER］
-［REVERB/PITCH］
-［AUTO/TAP］
3 Select UP button
6 LOAD A Button
4 Select DOWN button
7 LOAD B Button
5 Rotary Selector
Channel Switching
Select the channel for applying the sound effects,
from among channel A, channel B and the master.
Effect Selection
You can select from the eight kinds of effects that
are assigned to the four function buttons.
BPM Display Switch
You can select a BPM (beat per minute) display
that is either AUTO or TAP.
BPM (AUTO)
The BPM value that is detected in the song on the
selected channel is displayed.
BPM (TAP)
When you press either the LOAD A or LOAD B
button twice or more in succession, the interval
between presses is displayed as the BPM.
Effect Beat
The cycle (timing) of the sound effects, such as
reverb, transition and echo, is set based on the
displayed BPM. This cycle (timing) can be
adjusted using the select UP or the select DOWN
buttons. However, if the pitch is selected in the
effect selection, you can use the select UP or
select DOWN buttons to adjust the pitch.
Note
SEP-C1 Operation Buttons Functions that are Linked with the [DJ Play] screen
Function [INPUT SELECT] Switches Channels : Channel A, Channel B, Master
Function [DELAY / ECHO] Select Effect : Delay / Echo
Function [PAN / TRANS] Select Effect : Pan / Trans
Function [FILTER / FRANGER] Select Effect : Filter / Franger
Function [REVERB / PITCH] Select Effect : Reverb / Pitch
Function [AUTO / TAP] Switches BPM Display : AUTO / TAP
LOAD A Button TAP Input
LOAD B Button TAP Input
Select UP Button Effect Beat : Down
Select DOWN Button Effect Beat : Up