Pioneer DV-410V-S - Manual (Page 48)

09
48
En
USB troubleshooting
Note
• Static electricity or other external influences may cause malfunctioning of this unit. In this
case, unplug the power cord and then plug back in. This will usually reset the unit for proper
operation. If this does not correct the problem, please consult your nearest Pioneer service
center.
No HDMI video output. • Make sure that you’ve selected this player as the HDMI input in
the settings for the component you’re using. You may need to refer
to the instruction manual of the component to do this.
• Check that the HDMI cable is connected properly and that the
cable isn’t damaged.
• Check that components connected using the HDMI interface are
switched on and HDMI compatible.
• This unit has been designed to be compliant with HDMI
(High-Definition Multimedia Interface). Depending on the
component you have connected, using a DVI connection may result
in unreliable signal transfers.
• Make sure the resolution on this player matches that of the
component you have connected using HDMI. See HDMI Resolution
on page 36 to change the HDMI resolution. See Resetting the
output resolution to the default setting with HDMI connection on
page 14 if you want to reset the output resolution.
No multichannel HDMI
audio. • Make sure the HDMI Out setting is set to Auto (page 35). See
also About the HDMI audio output settings on page 40.
Component Out cannot be
set to Interlace. • You can use the Interlace setting if the HDMI Resolution is set to
720x480i (NTSC)/720x576i (PAL) (page 36).
A connected DVI component
(with HDCP) doesn’t work
with this player. • This unit has been designed to be compliant with HDMI
(High-Definition Multimedia Interface). Depending on the
component you have connected, using a DVI connection may result
in unreliable signal transfers.
Problem Remedy
Problem Remedy
USB mass storage device is
not recognized by the
system. • Make sure you have completely inserted the USB connector to
this unit.
• Check that the memory format is FAT16 or FAT32.
• USB devices with an internal USB hub are not supported.
Files don’t show up in the
Navigator/Photo Browser. • The files must have the correct file extension (page 6).
• Make sure the file permission hasn’t been restricted (through a
password, etc.).
Can’t play WMA or
MPEG-4 AAC files. • The files were recorded using DRM (digital rights management)
or FairPlay copy-protection. This is not a malfunction.
DV410V_UK_EN.book 48 ページ ２００８年２月２０日 水曜日 午後２時４４分