Pioneer MEH-P9100R - Manual (Page 13)

12
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
Installing the Unit on a Left-Hand
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 11)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Fig. 11
2. Cut the extra portion of the belt at
the center of the inner holder.
(Fig. 12)
• Keep the cut-off portion of the belt as a
spare.
Fig. 12
3. Install outer holder on the inner
holder and secure with screws.
(Fig. 13)
• Tighten the screws with the supplied hexago-
nal wrench.
Fig. 13
4. Install the remote control unit in
the holder. (Fig. 14)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Fig. 14
Release Section
Screw
Outer holder
Belt
Inner holder