Pioneer XW-NAS3 - Manual (Page 13)

Bluetooth® ADAPTER for Wireless Enjoyment of Music 04
13
En
English
Français
Español
1 Switch the unit into standby and connect
Bluetooth ADAPTER to the ADAPTER PORT
located in the rear panel.
2 Press  STANDBY/ON.
3 Press INPUT to switch to Bluetooth
ADAPTER input mode. 1
The Bluetooth ADAPTER indicator blinks.
Setting the PIN code
Set this unit’s PIN code to the same setting as
that for the Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
1 Switch the unit into standby.
2 Press and hold  for three seconds.
The Bluetooth ADAPTER indicator will flash,
and the PIN code will be changed. The number
of flashes corresponds to the newly set PIN
code as follows:
• 1 flash: 0000
• 2 flashes: 1234
• 3 flashes: 8888
Repeat step 2 until the PIN code is reset to the
value desired.
Pairing Bluetooth ADAPTER and
Bluetooth wireless technology
device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2 For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 When the Bluetooth ADAPTER indicator
blinks, press .
The Bluetooth ADAPTER indicator will blinks
fast, and the unit will enter the pairing standby
mode.
2 Switch on the Bluetooth wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
Pairing begins.
3 Check to see that the Bluetooth ADAPTER
is detected by the Bluetooth wireless
technology device.
The Bluetooth ADAPTER indicator lights when
Bluetooth wireless technology device is
connected.
The Bluetooth ADAPTER indicator blinks slowly
when Bluetooth wireless technology device is
not connected. In this case, perform the
connection operation from the side of the
Bluetooth wireless technology device.
Note
1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, Bluetooth ADAPTER input mode cannot be selected even
if INPUT is pressed.
INPUT
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
INPUT
XW-NAS3_SYXJ.book 13 ページ ２００９年８月７日 金曜日 午前１０時２１分