Baby Jogger ASTM F833-07A - Manual (Page 6)

9 8
Raised Kickers
Basket
1 To use the raised kicker, pull up
on seat flap above the footplate,
and remove the kicker stand
from storage pocket. Attach the
kicker stand to the seat with the
hooks provided under seat flap.
2 Attach kicker stand by
wrapping both sides of the
webbing under the footplate.
Thread one side of the velcro
webbing through the D ring
of the other side, and secure
velcro together.
3 When not using the raised
kicker, tuck the kick stand
and the webbing straps into
the pocket provided under
the seat.
Reclining Seats
1 To recline: Pinch the clamp behind the seat, and slide it down to desired recline. Pull seat down on
both sides to match recline position of clamp.
Reverse steps to return to the upright position.
• Weather Cover: If desired, pull weather cover
down and over the seat back mesh. Secure
firmly over both sides of seat. When not in use,
roll weather cover up and fasten with elastic
loop and barrel provided under top of the seat
fabric.
1 Remove child from stroller.
From the front of the stroller:
Remove lower seat fabric to
expose bottom front portion
of frame. Fasten basket Velcro
around frame tubing on right
side. Repeat on left side.
Re-apply seat fabric to frame
once complete.
3 From the rear of the stroller:
Fasten the top snaps of the
basket around frame tubing
above the middle support
bar. Fasten the bottom snaps
around the frame tubing
above the middle support
bar. Repeat on other side.
2 Tilt stroller back so the handle
is flat on the floor. Fasten
front middle snap of the
basket around frame tubing
under the footwell. Return
stroller to upright position.
4 Fasten the middle snap of
the basket around center
frame tubing, above the
middle support bar.