Scarlett SC-1050 - Manual (Page 3)

www.scarlett-europe.com SC-1050 3
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read this instruction manual carefully before use and keep in a safe place for future reference.
· Incorrect operation and improper handling can lead to malfunction of the appliance and injuries to the user.
· Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the
mains voltage in your home.
· For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than
described in this instruction manual.
· Do not use outdoors.
· Always unplug the appliance from the power supply before cleaning and when not in use.
· To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other liquids. If it was
happened DO NOT TOUCH the appliance, unplug it immediately and check in service center.
· Do not take this product into a bathroom or use near water.
· Do not place appliance or parts near an open flame, cooking or other heating appliances.
· Close supervision is necessary when it is used near children.
· Do not leave the appliance switched on when not in use.
· Do not operate after malfunction or cord damage.
· Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in
the nearest service center only.
· Keep the cord away from sharp edges and hot surfaces.
· Do not pull, twist, or wrap the power cord around appliance.
· Never insert fingers, pencils or any other object thorough the guard when the fan heater is operating.
· To reduce the risks of electric shock do not switch the appliance by wet hands.
· For repair or accessories, contact an authorized service center only.
· Operating unit should be not closer than 0.9 m to flammable or easy deformable under high temperature objects.
· When the fan heater is on, move it away from the wall socket and make sure that the cord is not in front of the air
outlet grill. Do not install the unit closer than 0.3 m to any objects (wall mounting requires free space >0,5 m to a
ceiling).
· If, however, the airflow is inadvertently obstructed during use, the built-in thermal safety cutout will automatically
switch off the appliance.
CAUTION:
· Do not cover the appliance when it is in use.
· Do not use a fan heater in rooms less than 4 m 2 area.
OPERATION
· Set the mode switch to minimum position.
· Insert the plug to the power supply.
MODE CONTROL
· Set the mode switch to the required position:
- Off;
- Fan (airflow without heat);
I - Warm airflow (900 W);
II - Hot airflow (1800 W).
· The indicator light should light up, when you set the mode switch to any position except off.
THERMOSTAT
· Set the thermostat to maximum position.
· When the ambient temperature raises to satisfying level, slowly turn the thermostat counterclockwise. The room
temperature thus will be kept at the set level.
· If you want to change the room temperature, you can make another regulation: turn the thermostat clockwise to
arise the temperature and counterclockwise to lower it.
ATTENTION:
· Should the unit overheat, provided safety device will switch it off automatically. In such case switch the appliance
off and unplug. Check all vents and try to restart again after at least 5 minutes. If it does not operate, contact a
Service center.
NOTES:
· The room must be closed, if not, using of fan heater will not make good result because of heat leakage.
CARE AND CLEANING
· The fan heater should be cleaned regularly, otherwise the efficiency of heating may be reduced.
· Always unplug the fan heater and allow it to cool down before cleaning.
· Wipe the outer surface of appliance with a soft damp cloth.
· From time to time clean the inside of the fan heater with vacuum cleaner, operating at low setting.
· Do not use abrasive cleaners, gasoline, thinner or other chemicals to clean the fan heater.
STORAGE
· Complete all requirements of chapter CARE AND CLEANING
· It is recommended to keep the original box for after season storage.
· Keep the appliance in a cool, dry place.