Black & Decker SDC740 - Manual (Page 6)

10 9
13. Place the appropriate number of spacers determined in step 9 on each
screw to the appliance will be even (M).
Note: For spacer installation, you may require assistance (in mounting) in order to
hold spacers in place while securing the appliance at the same time. If assistance
is not available, use a small clamp to hold the spacers in place while you position
the appliance.
Important: Top panel of coffeemaker is removable to make installation easier.
Simply grip the panel at the rear and pull back to remove (see illustration F).
Once removed, mount in place following the directions below and then slide
coffeemaker back on the panel track to reattach appliance once the panel has
been mounted.
14. Once spacers are set, hold panel up and tighten nuts onto each of the screws
to secure.
Note: Always tighten nuts to ensure the appliance does not move or shake during
operation.
15. Once the panel is secure, reattach coffeemaker to panel by lifting appliance
up, aligning it with the track on the panel and then sliding it back into place.
16. Pull out cord from cord storage behind appliance and plug into standard
electrical outlet. Extra cord can be fed back into storage or hung over cord
management hook behind unit (see illustration G).
Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Note: If you are connecting another †SpaceMaker™ appliance into the Save-A-
Plug™ outlet, make sure you can easily unplug the appliance after each use.
17. Your †SpaceMaker™ appliance is now ready for use!
M
5. With the paper securely taped in place against the lip, fold the rest of the
mounting template back against the underside of cabinet surface, bending
it to remain flush against both the back of the lip and the underside of the
cabinet (K).
Important: Do not align screw holes on template with the partition between
cabinets, as this will prevent you from installing the appliance properly. Pay close
attention to where the drill holes will be set so as not to damage your cabinets
during mounting. Drilling through your cabinet’s partition may cause damage to
cabinets and prevent proper installation.
6. Drilling from under the cabinet up, drill holes through the 4 places marked
on the template using a ¼-inch drill bit (see illustration E).
Important: Always ensure you are drilling straight up through the marked
mounting hole on the template. Drilling at an angle may prevent proper
installation and may damage cabinets if the drill bit pierces the partition.
7. Once holes are drilled, remove tape and mounting template and save
template with your instructions in case you move or wish to remount at
a later time.
8. Wipe dust and debris off inside cabinet surface. Also, make sure under side
of cabinet is clean.
9. Place a washer inside the cabinet over each of the 4 holes you drilled.
10. Now, use your ruler or the paper ruler provided to measure the overhang
height, placing your ruler vertically against the underside of the cabinet
behind the overhang. This number determines the number of spacers you
need, using a number of spacers equal to the overhang height. For example,
a 1” overhang would use 2, ½” spacers on each of the rear holes (L).
11. Place a washer inside the cabinet over each of the 4 holes you drilled.
12. Drop one of your screws through each of the washers covering the holes
in the cabinet, from inside the cabinet down.
K
L