Baby Trend 8181bt - Manual (Page 3)

Before you begin: The Baby Trend Playard is designed so that, when
properly setup, the fabric of the playard places pressure on the 4 top rails
making them nearly impossible to unlock. This safety feature is activated
when you push down on the playard floor to lock the bottom rails. When
setting up the playard, if you allow the bottom rails to lock before locking
the top rails, the fabric pressure will not allow you to lock the top rails.
Please see (Fig. 3.) for the proper position of the bottom of the playard
when locking the top rails.
1. Unzip bag and remove Playard frame (Fig. 1). Undo the 3 Velcro
straps and set mattress aside (Fig. 2).
2. Stand Playard on legs keeping feet of playard close together as shown
in figure 3. Pull up on top rails until all rails “click” and “lock”.
* READ IMPORTANT: In order to continue, the handle in the
center of the floor of the Playard MUST remain raised in order
for the rail to lock (approx. 45.7 cm or 18 inches). The feet of the
playard should almost touch each other. All 4 bottom rails must
be pointed upward in order to LOCK top rails.
3. Push down on center of Playard floor until it is flat and locks into
position (Fig. 4). The center lock mechanism will lock automatically.
The center lock will rotate clockwise about 90 degrees as it locks.
NOTE: Test rails to make sure they are locked. Push down on each
rail making sure they are rigid and in a set position.
WARNING:
All top rails MUST be
straight and locked in position or child may
become entrapped and suffocate.
See figure 5 and 6.
4. Place mattress in Playard with padded side up (Fig. 7).
NOTE: DO NOT insert mattress if using bassinet feature. Go to
bassinet instructions.
5. Feed the 6 Velcro straps (found underneath the mattress), 3 on each
end of the mattress pad, through the slots on the bottom of the sides
of the Playard. Fasten the Velcro tabs to the underside of Playard to
prevent the mattress from moving (Fig. 8) (Fig. 9).
WARNING:
To prevent child from
suffocating, Velcro straps MUST be secured
to underside of Playard.
6. Attach the organizer, to any side of the playard, by pushing the plastic
clips down over the top rail. (Fig. 10). The maximum weight capacity
of the organizer is 3 pounds.
Playard assembly is now complete and ready to use.
Figure 1.
Figure 2.
Figure 3
Figure 4
Figure 5
3
FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA
Figure 6
TO ASSEMBLE PLAYARD