Scarlett SC-1055 User Manual
Page 3
www.scarlett-europe.com
SC-1055
3
GB
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read all instruction manuals before use and save it for future references.
· Before first switching on check that voltage indicated on the rating label corresponds to the mains voltage in your home.
· For home use only. Do not use for industrial purposes. Use the appliance only for its intended use.
· Do not use outdoors or in damp area.
· Do not immerse the appliance and cord in water or other liquids.
· Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
· Do not allow the cord to touch sharp edges and hot surfaces.
· Always unplug appliance from the power supply when not in use.
· Do not operate the appliance with damaged cord or plug, or after the appliance malfunctions, or has been dropped or damaged in any manner. To
avoid the risk of electric shock, do not disassemble the appliance; take it to a service center for examination, repair or mechanical adjustment.
· Close supervision is necessary when the appliance is used near children.
· Do not leave appliance unattended while operating.
· The heater must be used only in the upright position.
· Unit surface temperature of the appliance is high, thus do not touch it, except the handle.
· Operating unit should be far away from the flammable or easy bulging under high temperature objects.
CAUTION:
· To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
· Do not cover the appliance when in use.
ASSEMBLING
· First turn the unit upside-down.
· Fit wheels to the heater body.
· Place heater normally and make sure that it is inconvertible.
USING THE APPLIANCE
· Set thermostat to minimal position and power switch to Off position, plug in the appliance.
POWER SELECTOR
· You can adjust heater current power using power regulator:
Off;
Medium power;
II
Medium power;
III
Maximum power.
THERMOSTAT
· Set thermostat to maximum position.
· If you want to change the room temperature, you can make another regulation: turn the thermostat clockwise to arise the temperature and
counterclockwise to lower it.
TIMER OPERATION
· Set the timer to any operation time (12 hours maximum).
· In timer position CONTINUOUS the heater will work continuously.
NOTES:
· The room must be properly sealed, if not, using of heater will not make good result because of heat leakage.
· After use, turn the power selector to the OFF position, then turn the thermostat to the LOW position and unplug from power supply.
CLEAN AND CARE
· The heater should be cleaned regularly to wipe out the dust. As this may result the radiating unefficient.
· Unplug from the power supply and allow the appliance to cool down.
· Wipe out with a soft damp cloth. Do not use detergent or abrasives.
· Do not scrap the surfaces with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint coat.
STORAGE
· Switch off and unplug the appliance. Ensure the heater is completely cool.
· Complete all requirements of chapter CLEAN AND CARE.
· The cord could be winded into a cord storage compartment inside the body.
· Keep the appliance in a dry cool place.
RUS
·
.
,
.
·
,
,
,
.
·
.
.
·
.
·
.
·
,
.
·
,
.
·
,
.
·
,
,
.
,
.
·
.
·
.
·
.
·
,
.
·
.
:
·
,
.
·
.
·
.
·
.