Toshiba Satellite L30 (PSL30) User Manual
Page 127
User’s Manual
B-7
Display Controller and Modes
2. In some cases DVD video playback images may not be displayed when
the display of the computer and a CRT display are used at the same.
Reduce the resolution, use the display of the computer only, use the CRT
display only or set display device in the multi-monitor, then play DVD.
■
Please refer to
in Chapter 8,
the application guide for the setting of each display device.
3. The DVD video overlay is not displayed when the display mode of CRT
display is set to high resolution and high refresh rate mode.
Please decrease the resolution and refresh rate of CRT display.
4. When the display mode is simultaneous LCD (internal liquid crystal
display) and the system goes into Standby or Hibernation Mode, you
can switch to the LCD (internal liquid crystal display) display mode by
pressing Fn + F5. Under this environment, however, you may not return
to the simultaneous LCD (internal liquid crystal display) display mode.
In these cases, perform the following steps:
In Advanced feature of Display Properties. Select the Display tab,
click the icon indicating a display device (display mode) you want to use.
5. When the LCD (internal liquid crystal display) display mode is selected,
the Virtual (Virtual Screen) display mode can be set. However,
afterwards, it may not possible to change the screen resolution to more
than 1280 × 1024 pixels in Highest (32bit) mode (for example, when
you attempt to set the resolution to 1600 × 1200 using the Screen
resolution slide bar and then select Highest (32bit) mode from the Color
quality drop-down menu).
In these cases, perform the steps below:
First, use the Screen resolution slide bar to select the 1280 × 800
resolution, and then change the resolution to more than 1280 × 1024
and select Highest (32bit) from the Color quality drop-down menu.
Display Properties
(Multiple Monitors) and ATI RADEON
XPRESS 200M Series Properties