Toshiba Magnia SG30 - Manual (Page 250)

261 Manually Configuring Clients for the Magnia SG30
Manually configuring clients using the Windows 95, 98 and
Windows Me operating system
5.375 x 8.375 ver 2.1
be ready to continue with your client configuration network
settings.
Installing the NIC using the Windows Me operating system
1 Click Start, Settings, Control Panel and double-click
Add New Hardware.
The Add New Hardware Wizard appears.
2 Follow the prompts of the Wizard accepting all defaults.
You should allow the Windows
®
Me operating system to
search for your network interface card. If it does not find your
particular card, or any errors occur, consult the installation
instructions supplied with your network adapter card.
The procedure that the wizard follows depends on the
requirements of the network adapter you are attempting to
install. Follow the instructions for each prompt. When
installation is complete, you will need to restart the computer.
Before restarting the computer, make sure that the Ethernet
cable is properly connected to both the network adapter card
and the Magnia SG30. After the computer restarts, you will
be ready to continue with your client configuration network
settings.
Operating system networking settings
Once you have a properly installed network interface card,
you need to make additional network settings so that the
client computer can communicate with the Magnia SG30.
You may need your Windows
® operating system setup disk to
complete this process.