New Buck Corporation 384 - Manual (Page 33)

FREESTANDING PEDESTAL OR LEGS
INSTALLATION
1. The Model 384 can be mounted as free standing with either a pedestal or Queen Anne legs.
A. To mount the pedestal Part No.(FA P14) to the heater lay the heater on its back (use a
drop-cloth to protect the back of the heater and the surface of your flooring). Place
pedestal against bottom of heater. Center pedestal from left to right and from front to
rear. Mark the holes on the angle on the top of the pedestal. Lay the pedestal aside.
Drill the marks. Replace the pedestal and secure with the provided screws.
B. For legs kit Part No.(FA FS384) place heater on its back. Your heater is equipped with
four leg mounting nuts.
Place a leg at each nut and secure leg with the bolts provided.
The legs are equipped with leveling bolts needed for leveling adjustments.
2. Stand heater to the upright position. Place heater in the desired location. At this point you
may want to secure the pedestal to the floor with screws or an “ell” bracket.
3. Hook up gas supply line. Check for leaks with mild soapy water. See page 5 Installation
Clearances and Gas Connection.
Page 29