Toshiba Magnia Z500 User Manual
Page 86
HW Diagnostics
Items of HW Diagnostics
84
[01. Sequential address read]
This subtest is a sequential reading of all the blocks on the
HDD, starting at block 0.
[02. Connection]
This subtest reads the logical sector at the end of the HDD, and
then recognizes if the drive is connected or not.
NOTE: The [01. Sequential address read] tests all areas of
the hard disk drive. If the capacities of installed hard disk
drives are large enough, the test may take a few hours.
If you do not know where the hard disk drives are connected
(host ID, SCSI ID and channel number of the SCSI
controller), you can find them from [01. INQUIRY] of [09.
SCSI TEST]..
SCSI HDD TEST (HDD)
Status
Error name
Meaning
01
CHECK CONDITION OR BAD
COMAND
Bad command error
03
DRIVE SELECTION FAILED
ID selection error
04
TARGET DRIVE BUSY
The target drive is busy
05
SCSI BUS TIME OUT
Time out error of SCSI bus
09
DMA BOUNDARY ERROR
DMA BOUNDARY occurred
0D
COMMAND TERMINATED
A command terminated
0E
QUEUE FULL
Command queue is full
80
NO SENSE
The sense data is invalid
81
RECOVERED ERROR
The execution of the command has correctly
finished because ofrecovery treatment
82
NOT READY
The condition does not satisfy for the com-
mand execution
83
MEDIUM ERROR
An error occurred because of the failure of a
medium
84
HARDWARE ERROR
A hard error that is impossibleto recover
occurred duringcommand execution
85
ILLEGAL REQUEST
CBD is illegal
86
UNIT ATTENTION
The function of hard disk drive has been
changed