Toshiba Portege R200 (PPR20) - Manual (Page 122)

PORTÉGÉ R200 7-8
HW Setup
Starting and Ending the BIOS Setup Program
Starting the BIOS Setup Program
1. Switch on your computer while pressing the Esc key.
If “Password =” is displayed, enter the user password and press the
Enter key.
Please refer to Chapter 6, the TOSHIBA Password Utility , for details
about the user password.
The “Check system. Then press [F1] key.” message is
displayed.
2. Press the F1 key.
The BIOS setup program will start up.
Ending the BIOS Setup Program
Save the changes and end the program.
1. Press the End Key.
The “Are you sure? (Y/N) The changes you made will
cause the system to reboot
.” message is displayed.
2. Press the Y key.
The configured settings are saved and the BIOS setup program ends.
The computer may reboot depending on the settings that were
modified.
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made.
1. Press the Esc key.
The “Exit without saving? (Y/N)” message is displayed.
2. Press the Y key.
The BIOS setup program will end.
Execute-Disable Bit Capability
This setting enables or disables the Execute-Disable Bit function.
The Execute-Disable Bit Capability setting is available in SYSTEM SETUP
(1/2).
Select either the Execute-Disable Bit Capability or settings in the security
controller to make changes. Please refer to the operating instructions
displayed in the settings screen.
Available
Make the Execute-Disable Bit Capability usable
(Available).
Not Available
Disable the Execute-Disable Bit Capability (Not
Available) (Default).