Starting the toshiba pc health monitor – Toshiba Tecra R10 User Manual
Page 196
G-2
User’s Manual
TECRA R10
Starting the TOSHIBA PC Health Monitor
The TOSHIBA PC Health Monitor can be started using the following
methods:
■
Double click TOSHIBA PC Health Monitor in the Welcome Center.
■
Click Start -> All Programs -> TOSHIBA -> Utilities -> PC Health
Monitor.
■
Click the icon (
) in the notification area, then click the “
TOSHIBA
PC Health Monitor is not enabled. Please click here
for more details
.” message when it is displayed. (*)
No matter which method is used, the TOSHIBA PC Health Monitor
explanation screen will be displayed.
Clicking “Next” will display the “
PC Health Monitor Software
Notice & Acceptance
” screen. Please carefully read the information
displayed. Selecting “Please enable software now. I agree with the
terms and conditions and use and sharing of the information
collected.” and clicking “OK” will enable the program. By enabling the
TOSHIBA PC Health Monitor software, you agree with these terms and
conditions and to the use and sharing of the collected information. Once
the program is enabled, the TOSHIBA PC Health Monitor screen is
displayed, and the program will begin monitoring system functions and
collecting information.
(*) This message will no longer be displayed after clicking “Please enable
software now” or “Please disable software now” on the “
PC Health
Monitor Software Notice & Acceptance
” screen.
If a TOSHIBA PC Health Monitor message is displayed.
A message will be displayed if any changes which may interfere with the
operation of the program are detected. Follow the instructions displayed on
screen in the message. However, if the following special message is
displayed, carry out the procedures listed below.
If the “
It is possible that the PC cooling performance has
decreased. Please click [OK] to run the TOSHIBA Cooling
Performance Diagnostic Tool to check the cooling
performance of your PC.
” message is displayed.
1. Click “OK” to start the “TOSHIBA Cooling Performance Diagnostic Tool”.
2. If the “
It is possible that the PC cooling performance
has decreased. Please clean the cooling module
according to the instructions in your PC User’s
Guide.
” message is displayed after running the “TOSHIBA Cooling
Performance Diagnostic Tool”, the cooling module requires cleaning.
Refer to the
3. After cleaning the cooling module, run the “TOSHIBA Cooling
Performance Diagnostic Tool” again.
Click Start -> All Programs -> TOSHIBA -> Utilities -> TOSHIBA
Cooling Performance Diagnostic Tool.