Toshiba BDX3300 - Manual (Page 3)

3
English
Disposal of your old product and
batteries
Following information is only valid for EU-
member States:
Disposal of products
The crossed out wheeled dust bin symbol
indicates that products must be collected and
disposed of separately from household waste.
Integrated batteries and accumulators can
be disposed of with the product. They will be
separated at the recycling centres.
The black bar indicates that the product was
placed on the market after August 13, 2005.
By participating in separate collection of
products and batteries, you will help to assure
the proper disposal of products and batteries
and thus help to prevent potential negative
consequences for the environment and human
health.
For more detailed information about the
collection and recycling programmes available
in your country, please visit our website
( http://www.recycle-more.co.uk/ ) or
alternatively please contact your retailer where
the product was purchased.
Disposal of batteries and/or accumulators
The crossed out wheeled dust bin symbol
indicates that batteries and/or accumulators
must be collected and disposed of separately
from household waste.
If the battery or accumulator contains more
than the specified values of lead (Pb),
mercury (Hg), and/or cadmium (Cd) defined in
the Battery Directive (2006/66/EC), then the
chemical symbols for lead (Pb), mercury (Hg)
and/or cadmium (Cd) will appear below the
crossed out wheeled dust bin symbol.
By participating in separate collection of
batteries, you will help to assure the proper
disposal of products and batteries and
thus help to prevent potential negative
consequences for the environment and
human health.
For more detailed information about the
collection and recycling programmes available
in your country, please visit our website
( http://www.recycle-more.co.uk/ ) or
alternatively please contact your retailer
where the product was purchased.
General Information
This appliance may be fitted with a non-
rewireable plug. If it is necessary to change the
fuse in a non-rewireable plug the fuse cover must
be refitted. If the fuse cover is lost or damaged,
the plug must not be used until a replacement
available from the appliance manufacturer is
obtained. If the plug has to be changed because
it is not suitable for your socket, or becomes
damaged, it should be cut off and an appropriate
plug fitted following the wiring instructions below.
The plug removed must be disposed of safely as
it is hazardous if inserted into a live socket.
1 Important
Safety and important notice
Warning:
• Risk of overheating! Never install the product in a
confined space. Always leave a space of at least
10cm around the product for ventilation. Ensure
curtains or other objects never cover the
ventilation slots on the product.
• Never place the product, remote control or
batteries near naked flames or other heat
sources, including direct sunlight.
• Only use this product indoors. Keep this product
away from water, moisture and liquid-filled
objects.
• Never place this product on other electrical
equipment.
• Keep away from this product during lightning
storms.
• Where the mains plug or an appliance coupler is
used as the disconnect device, the disconnect
device shall remain readily operable.
LASER
CAUTION:
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
CAUTION:
VISIBLE AND INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS DEFEATED. DO
NOT STARE INTO BEAM.
LOCATION:
INSIDE, NEAR THE DECK MECHANISM.
EU Conformity Statement
This product is marked with "CE" and complies
therefore with the applicable harmonized
European standards listed under the Low
Voltage Directive 2006/95/EC and the EMC
Directive 2004/108/EC. ErP Directive 2009/125/
EC, R&TTE 1999/5/EC
Responsible for CE-marking is
TOSHIBA INFORMATION SYSTEMS (U.K.) LTD,
Toshiba Court, Weybridge Business Park,
Addlestone Road, Weybridge,Surrey,KT15 2UL,
United Kingdom
Pb,Hg,Cd