Toshiba Camileo SX500 - Manual (Page 29)

User’s Manual 18 EN
SE
TU
P
HINT
To immediately activate the power save mode
i Press the POWER button briefly to activate the power save function.
About the standby mode
i To turn off the camcorder only briefly, you can close the monitor unit to put
the camcorder in the standby mode. The standby mode uses almost no
power. When the monitor unit is opened again, the camcorder turns on
immediately and you are ready to shoot or view images without any delay.
CAUTION
If the K icon appears...
i When a picture is taken, the date and time it was captured are recorded
with it. If the date and time settings have not been completed (page 19),
the date and time cannot be recorded with the captured images. For this
reason, immediately after the camcorder is turned on, the “Set date and
time” reminder briefly appears, after which the K icon is shown on the
Recording Screen. To have the date and time recorded with the images,
please complete this setting before capturing images.
i Due to the characteristics of the camcorder, the outer surface may
become warm during use, but this does not indicate a malfunction.
i If the camcorder starts to feel uncomfortably hot during use, you
might temporarily discontinue use until it cools down, or try holding it
in your other hand for a while.
Please use a tripod or other support when using the camcorder for a
long time.
<Caution>