Beko DRCS 76 W - Manual (Page 17)

17 - EN
start the programme.
C
Any laundry added after the drying
process has started may cause the
already dried clothes in the machine
to intermingle with wet clothes and the
drying result will not be as good.
C
Laundry may be added or taken
out as much as desired during a drying
process, but as this process will interrupt
drying continuously, it will extend the
programme duration and increase
energy consumption. Therefore, it is
recommended to add laundry before the
drying programme is started.
Child-proof lock
There is a childproof lock to prevent any
programme interruption due to the
pressing of keys while the programme
is on. The loading door and all keys
except the “On/Off” key on the panel are
deactivated when the child-proof lock is
active.
In order to activate the childproof lock, press
on the “Start/Pause/Cancel” and “Cancel
audio warning” buttons simultaneously for 3
seconds.
To start a new programme after the
programme is over or to interrupt the
programme, the childproof lock should be
deactivated. To deactivate the child-proof
lock, press the same buttons again for 3
sec.
C
2 beeps when activating and 1
beep when deactivating the child-proof lock
is heard.
Ending the programme through
canceling
The programme which is selected first will
keep on going even if the position of the
programme selection button is changed.
A new programme can be selected and
started after “Programme cancel” is
“Ready to wear”:
- Starts to illuminate when the drying degree
reaches “Ready to wear” step and remains
illuminated until the next step.
“Final / Anti-creasing”:
- Illuminates when the programme comes
to an end and anti-creasing function is
activated.
C
If more than one LED light up
or flash concurrently, it means there is
malfunctioning or a failure (please see,
Solution suggestions for problems).
Changing the programme after
the programme has started
You can use this feature after your machine
has started to dry your clothes under higher
or lower temperatures.
For example;
Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to “Cancel”
the programme in order to select “Extra
Dry” programme instead of “Iron Dry”
programme.
Select the “Extra Dry” programme by
rotating the programme knob.
Press “Start/Pause/Cancel” button to start
the programme.
C
The programme which is selected first will
go on even if the programme selection
button is moved and another programme
mode is selected while the machine is
operating. You must cancel the ongoing
programme in order to change the drying
programme. (See. Ending the programme
through cancelling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button
to switch the machine to “Pause” mode.
Drying process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to