Blount 853PRO User Manual
Page 7
Advertising
© 2008 ICS, Blount International Inc. Specifications are subject to change without notice. REV0708 F/N 71904
853PRO OPERATOR’S MANUAL
8
SET-UP
STEP 1
Loosen the side cover nuts and
remove the side cover.
GUIDE BAR AND DIAMOND CHAIN INSTALLATION
STEP 4
Mount the chain on the bar starting
at the drive sprocket & continue
over the bar nose.
STEP 2
Place the bar onto the studs and the
chain adjustment pin.
STEP 5
Make sure all of the drive links are
inside the bar groove, then pre-
tension the chain.
STEP 3
Turn the chain-tensioning screw
CCW until the bar comes into
contact with the drive sprocket.
Install the chain correctly. The
bumper must always lead the
segment into the cut as shown here.
Advertising