Baby Trend Compact Back Pack 2512 - Manual (Page 5)

5
TO INSTALL CANOPY:
* To install canopy, attach the 3 hook and loop fasteners on rear of backpack.
See figure 12. Next, attach the front end of the canopy by snapping the
female ends of the 2 snaps onto the male snaps attached to the front of the
backpack, then attach the hook and loop fastener through the plastic eyelet
and secure together. See figures 13 and 14.
TO PUT ON OR REMOVE THE BACKPACK:
WARNING:
Use extreme care when placing
the Backpack on your back. The combined weight
of the Backpack and child may be very difficult to
control and you may loose your balance. Always
have a second adult assist you in putting on or
removing the backpack.
* The easiest method for putting on the Backpack is from a seated position on
a bench or other raised flat surface
* Have a second adult assist you in putting on the backpack.
* Insert each arm through the shoulder straps and buckle the waist belt around
your waist. Attach the sternum strap.
* Check that the childʼs legs are not trapped between the Backpack and your
back. Check that the child is comfortable.
* Children tend to fall asleep in Backpacks. Periodically check you childʼs
position and watch for any breathing problems.
TO ATTACH DIAPER BAG TO FRAME
* Insert 2 buckles together, located at the top of the diaper bag and on the top
rear of the backpack. See figure 15.
* Attach the two lower straps around the frame and snap together. See figure
16.
Fig. 12
Fig. 13
Fig. 14
Fig. 15 Fig. 16
SNAP
LOCATION