Descriptions – E.T.I. SOUND SYSTEMS B 52 L User Manual
Page 4
4
1
2
3
4
17
1.
AMPLIFIER:
The Matrix 1000 subwoofer amplifier
panel.
2.
LEFT SPEAKER OUTPUT:
Speakon connector output
for left monitor.
3.
COOLING FANS:
Rear cooling fans for built-in
subwoofer amplifier. Ensure these cooling fans are
clear of external obstructions for efficient operation.
4.
WARNING INFORMATION
. Please read and
adhere to these instructions to ensure safe
operation.
5.
POWER CORD CONNECTOR:
For attachment of
the included power cord.
6.
FUSE HOLDER:
Contains primary 6A fuse.
7.
POWER ON/OFF SWITCH:
Turns the Matrix 1000
on and off.
8.
RIGHT SPEAKER OUTPUT:
Speakon connector
output for right monitor.
9.
PHASE SWITCH:
Sets the polarity of the Matrix
1000.
10. SUBWOOFER GAIN CONTROL: Controls the levels
of Gain to the subwoofer.
11. GROUND/LIFT SWITCH: Remove ground from
circuit to eliminate excessive 60-cycle hum.
12. RIGHT MONITOR GAIN CONTROL: Controls the
levels of Gain to the right side full range speaker.
13. XLR BALANCED RIGHT FULL-RANGE OUTPUT:
Sends parallel full range signal out to other systems
or components.
14. XLR BALANCED RIGHT FULL-RANGE INPUT:
Connects the right side full range speaker to your
mixing console.
15. LEFT MONITOR GAIN CONTROL: Controls the
levels of Gain to the left side full range speaker.
16. XLR BALANCED LEFT FULL-RANGE OUTPUT:
Sends parallel full range signal out to other systems
or components.
17. XLR BALANCED LEFT FULL-RANGE INPUT:
Connects the left side full range speaker to your
mixing console.
18. LEFT CHANNEL CONTROLS
19. RIGHT CHANNEL CONTROLS
DESCRIPTIONS
NOTE:
Use Pin #:
1+ and 1-