Black & Decker VM610 User Manual

Page 5

Advertising
background image

Your product is fitted with a motor safety device, which protects the motor from
overloading.

When the unit is overloaded, the thermal-cut-off will trip the

connection to the motor, thus preventing the unit from further operation. If this
does happen, unplug the unit from main and let the unit cool down for 20-25
minutes. The thermal-cut-off will reset and the unit will be operational once again.

How to care for your Vacuum Cleaner

Your appliance is equipped with a fabric dust bag. If you notice the vacuum
cleaner's suction power is below normal levels, check the dust indicator by
selecting the maximum power and lifting the cleaning tool off the floor. If it turns
red, change/clean the bag.

To change the dustbag, turn off the appliance and unplug it. Lift up the latch to
gain access to the dustbag compartment and raise the cover. Pull the handle up
to remove the bag holder.

Handle the bag carefully.

Refer the 'Dust Bag

Emptying' instructions to empty it. Do not forget to regularly clean the dustbag
and filter. The efficiency of your cleaner and the life of the motor depends on it.

Clean the vacuum cleaner body with a damp cloth. Do not use any abrasives.

Change of Filters

Motor protection air filter is located in the dust bag compartment and protects the
motor from dust. To reach this filter, lift up the grill which secures it and replace it
with a new one after emptying the dust bag 5 times.

Attention: Dot not use the vacuum cleaner without the motor protection filter.
There are also filters at the end of the unit. Press the lever down to gain access to
this filter. Clean this filter regularly for more purified air.

Dust Bag Indicator

When the dust bag or air filters are full of dust, the "dust full indicator" on top of
the body will be covered by red indications. This shows that you need to empty
the dust bag or clean the air filters.

Dust Bag Emptying

Make sure to empty the dust bag after every five uses. The motor life will be
effected if worked with full dust bag.

You can empty the dustbag in the following ways:

• Hold the dustbag over a dustbin. Remove the clip by sliding it off the dustbag

sideways.

• Shake the contents of the dustbag in to the dustbin.

• Close the dustbag by sliding the clip back onto the bottom edge of the

dustbag.

Hint's

• Never put the appliance in water

• Do not touch the plug or the vacuum cleaner with wet hands

• Dot not use your vacuum cleaner outside the house, on wet surfaces, or to pick

up wet or humid dirt.

• Do not suck up inflammable liquids such as cleaning fluids, gasoline, etc, or

their vapours.

• Do not vacuum hard, sharp or over-large objects, matches, hot ashes, cigarette

butts or similar materials

Red

Advertising