Sharp SJ-PD691SB - Manual (Page 6)

6
Water tank
Water level Cap
How to pour water
WARNING
■
Fill with potable water only.
1 Open the cap of the water tank,
and fill the tank with water.
2 Close the cap of the water tank.
(If it isn’t, water might spill
when the door is opened
or closed.)
NOTE
• Do not open or close the door roughly. Water may spill from
the water tank.
• Do not pour any liquids except for water. If other liquid such
as juice is poured in, it might cause a failure. Before pouring
hot water into the tank, wait until it gets cold.
(Upper temperature limit: approximately 50°C)
How to drink water
1 Push the lever with a glass.
(Water comes out.)
2 Move the glass slowly away from
the lever. (The lever returns to the
original position, and water stops.)
NOTE
• For hygienic reasons, replace the water in the water tank
approximately once a week.
• Throw away the water in the tray frequently. If do not, water
may overflow.
• If the water dispenser is not
used for an extended period of
time, clean and dry the water
tank thoroughly, and attach it to
the original position.
WARNING
■
Unplug the refrigerator first to prevent electric
shock.
■
Do not splash water directly on the outer cabinet
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
1 Remove the accessories e.g. shelves from the cabinet
and door. Wash them in warm soapy dishwashing
water; rinse in clean water and dry.
(Only fruit and vegetable shelf is not removable.)
2 Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3 Wipe the exterior with a soft cloth each time it is soiled.
4 Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
5 Wipe the control panel with the dry cloth.
NOTE
• To prevent damage to your refrigerator, do not use heavy
duty cleansers or solvents (lacquer, paint, polishing powder,
benzine, boiled water, etc.).
• If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
• The glass shelves weigh approximately 3 kg each. Hold
firmly when removing from the cabinet or carrying.
• When dropped the juice and the like near the control panel,
wipe off directly. It becomes cause of failure of the control
panel.
• Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
How to remove the water tank
(Remove it approximately once a month and wash it with
water.)
1
Push the lever and let out all water in the water tank.
2
Remove the pipe cover.
Disconnect the both ends of the joint pipe.
3
Remove the water tank from the door.
4
Remove the cover and take out
the mesh filter.
NOTE
Ensure that each parts are reattached. Bad reattaching may
cause water leakage.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
WATER DISPENSER
Lever
Tray
CARE AND CLEANING
Pipe cover
Joint pipe
When reattaching
Water tank
Door
2 1
When reattaching
Mesh filter Cover
(B068)02-07_Eng.fm Page 6 Thursday, August 20, 2009 10:04 AM